FullBack™ Backing Plate for GT90, GTTL90, GTSL90 16'' GearTrac (FB-GT90-16)


Product Information

This 1/4" thick anodized aluminum plate with tapped holes from YakAttack is used for strong installation of GT90GTTL90, GTSL90 GearTrac. Requires 1/2" X 16" flat area inside hull.
  • GT90, GTTL90, GTSL90 backing plate
  • Single pack
  • 16" long
  • Made in the USA
  • Covered by our Built for Life Guarantee
  • SKU: FB-GT90-16

Customer Reviews 5 (1 Review) Write a review of this product

5 Stars
16" trac, the necessary backing plate and the rigging needle

I purchased 2 16" tracs and then realized I needed the backing plates, but...installation was going to be rough. I bought the approp. sized rigging needle. The "trick" I used was a LARGE magnet to move the needles INTERNALLY within the Kayak to a point I could grab them. After that, installation was a breeze.